AppleOperator Note

Apple Diagnostics Reference Codes: What Each One Means

The codes Apple Diagnostics gives you, what Apple says they mean, and what to do next. Plus what a clean result still doesn't tell you.

Jonathan Brax6 min

People search these codes a lot, and Apple's own list is short on context. So here's the list in one place. The meanings below come from Apple's published reference code list. Where I add anything, it's what my team does with the result, not a guess about your specific Mac.

How to run Apple Diagnostics on a Mac if you haven't run the test yet.

The codes

CodeWhat Apple says it means
ADP000No issues found
CNW001 to CNW006Possible issue with the Wi-Fi hardware
NDC001 to NDC006Possible issue with the camera
NDD001Possible issue with USB hardware
NDK001 to NDK004Possible issue with the keyboard
NDL001Possible issue with the Bluetooth hardware
NDR001 to NDR004Possible issue with the trackpad
NDT001 to NDT006Possible issue with the Thunderbolt hardware
NNN001No serial number detected
PFM001 to PFM007Possible issue with the System Management Controller (SMC)
PFR001Possible issue with the computer's firmware
PPF001 to PPF004Possible issue with the fan
PPM001 to PPM015Possible issue with memory
PPN001Possible issue with power management
PPP001 to PPP003Possible issue with the power adapter
PPR001Possible issue with the processor
PPT001Battery not detected
PPT002, PPT003Battery will need to be replaced soon
PPT004Battery requires service
PPT005Battery not installed properly
PPT006Battery requires service
PPT007Battery needs to be replaced
VDC001 to VDC007Possible issue with the SD card reader
VDH002, VDH004Possible issue with a storage device
VDH005Unable to start macOS Recovery
VFD001 to VFD005, VFD007Possible issue with the display
VFD006Possible issue with the graphics processor
VFF001Possible issue with audio hardware
Source: Apple's Apple Diagnostics reference codes list. Apple updates it from time to time, so check there if a code isn't here.

Apple's official reference code list

What to do with a code

  1. Write down the exact code. Take a photo of the screen if that's easier.
  2. Unplug everything except power, keyboard and mouse, then run the test again.
  3. If the same code comes back, that part is the one to look at. If it doesn't, an accessory may have caused it.
  4. For battery codes, check System Settings > Battery for the condition reading too.
  5. If the code repeats, contact Apple or a repair shop and give them the code. It saves time.

What a clean ADP000 still doesn't tell you

ADP000 means none of the parts the test checks reported a fault. My team sees Macs pass and still have a sticky key, a bad speaker, a line on the screen or a problem that only shows up after it runs hot for a while. The test doesn't press keys, listen to sound or look at the picture.

Why a Mac can pass Apple Diagnostics and still be broken the full list of what it misses.

Is a Mac with an error code worth anything?

Usually, yes. A code points to one part, and a lot of Macs with a bad battery, keyboard or port still have value as a repair or for parts. Don't throw it out because of a code.

SellMac buys Macs that fail diagnostics. It's one of my companies.